10 Years standslone Smoke Alarm

Battery Operated

• Long-life lithium-ion battery sealed in the alarm to lengthen its life time to 10 years in standby condition.

Operating Light(LED)

• Flashes approximately every 53 seconds confirming unit is powered.

Low Battery Warning

• Alaem deeps 40 seconds when the batetery needs replacing.

Alarm Pause(Hush mode)

• Silence your smoke alarm by momentarily pressing the test btton when non-emergency smoke causes nuisance alarms. The red light flashes every 10 seconds to remind you hat the smoke alarm has been silenced. The alarm will automatically reset after 15 mins

Sensitivity Test Button

•  Test the sensitivity,circuitry,batteries,horn

Lound 85 Decibel Pieao Electric Alarm

• Automatically resets when hazardous condition has passed

installation instruction

1 Using needle-nose pliers or a utility knife, detach one locking pin from the mounting bracket to separate the alarm from the mounting bracket.

2  Draw a horizontal or vertical line 6 inches (10 cm) long on the area of ceilings or walls where this smoke alarm is  intended  to  locate  (see  Section  3  WHERE  TO LOCATE).

3   Locate the mounting bracket in your chosen position. Align  the  two  longest  mounting  slots  with  the  line. Draw a mark in the center of each slot.

4   Drill  the  holes  at the  marks with a 3/16-inch  (5mm) drill.

5    Insert  the  anchor  plugs  and  screw  the  mountingbracket to the chosen position. DO NOT OVER-TIGHT THE SCREWS, this will distort the mounting bracket.

6   Attach  the  alarm  to  the  mounting  bracket  and  turn clockwise to lock into place.

We also have Smoke Detectors, Fire Extinguishers, fire blankets, fire cannons, fire hoses, traditional smoke control panels and other firefighting equipment